In this chapter we will build the ported ESP VA-SDK firmware, flash it on to the device, provision the Wi-Fi and authorize the device to your Alexa Account, then test some of the smart home capabilities using Alexa voice commands available in this beta version of AFI.
Use the PlatformIO CLI to compile your firmware, upload the firmware, and monitor the serial output of your device. It will take some time to build and flash the app, but after that’s done you should see the stream of device logs in your terminal. If you receive an error for the port not being auto-detected, follow the Identifying the serial port on host machine instructions and try the command again. You can close the monitor session with the Ctrl + C keystroke combination:
pio run --environment core2foraws --target upload --target monitor
To provision the device, you must configure your Wi-Fi network credentials and authorize the application with your Alexa account using the ESP Alexa Phone Application.
abcdf1234or similar pop up. Simply press Done to continue.
With the prior steps completed, you will see a number of logs in your serial monitor, including some like the following:
I (17325) [http_transport]: Subscribing /capabilities/acknowledge... I (17535) [http_transport]: Subscribing /connection/fromservice... I (17735) [http_transport]: Subscribing /directive... I (17945) [http_transport]: Subscribing /speaker... ... I (20735) [directive_proc]: Name: EndpointForwarding ... I (22675) [directive_proc]: Name: SetAttentionState ... E (22685) [app_va_cb]: Enabling Mic
In order to interact with Alexa, you will need to say Alexa to the device. This will trigger the Espressif Wake Word Engine running on the device to enter the LISTENING attention state. For full details on the different attention states, please refer to our documentation . For more information on audio capture, see the SpeechRecognizer API Documentation
Try a variety of utterances to Alexa - the side LEDs should light blue up when Alexa is heard (if Alexa does not “wake up”, try speaking closer to the device):
The AFI device has Alexa Built-In, which means you can speak to Alexa directly on the device and Alexa will respond with voice on the device. However, this version of AFI from Espressif also supports Alexa Smart Home commands as a beta feature, which allows you to control attributes on the device.
The Alexa for AWS IoT sample application creates a virtual device called Light in your Alexa app, which supports two interfaces:
Since it’s a virtual device, it prints the updated status to the screen. We can test this out via voice or the Alexa app.
With either option, you should see a message like the following in your terminal:
I (97445) [alexa_smart_home]: Namespace: Alexa.PowerController, Name: TurnOn
Similarly, you can try to control the range of the brightness by one of the following:
With either option, you should see a message like the following in the serial monitor:
[app_smart_home]: *************** Light's Brightness changed to 60 ***************
This is useful not only because we have voice assistant on our device with Alexa, but we can use Alexa to control properties on the device itself!
On to creating a Custom Smart Home Device .
AWS IoT Kit now features direct access to
, which is a community-driven, questions-and-answers service. Search re:Post using the
Core2 for AWS
tag to see if your question has been asked and answered. If not, ask a new question using the
Core2 for AWS tag.